This is a public notice flyer to notify interested applicants of anticipated vacancies. Applications will NOT be accepted through this flyer. Interested applicants should review the "How to Apply" section of this flyer for more information on how to be considered. This flyer will be used as positions become available. There may or may not be actual vacancies filled from this flyer.
Who May Apply: US Citizens In order to qualify, you must meet the education and experience requirements described below. Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community; student; social). You will receive credit for all qualifying experience, including volunteer experience. Your resume must clearly describe your relevant experience; Must have completed trade school, if qualifying based on education, your transcripts will be required as part of your application. Additional information about transcripts is in this document. Minimum Qualifications (Screen Out Element): Ability to do the work of a Marine Machinery Mechanic (Drag Tender) without more than normal supervision. Your resume must demonstrate that you have the ability to repair and maintain marine equipment such as valves, motors and winches by using hand and power tools along with measuring devices - Failure to meet this Screen Out Element will result in an ineligible rating. Job Elements: The skills, knowledge, abilities, and personal characteristics listed below are important to succeed in the job: Knowledge of Equipment Assembly, Installation, Repair, etc Technical Practices (theoretical, precise, artistic) Ability To Interpret Instructions, Specification, etc. (includes blueprinting reading) Ability To Use and Maintain Tools and Equipment Knowledge of Materials Trouble shooting Physical Efforts: Work requires considerable standing, climbing, stooping, and bending, all which can cause exertion of the lower back and extremities. Work on ladders requires incumbent to work overhead or in a stretched, cramped, or awkward positions. May lift and carry items weighing approximately 40 pounds. Working Conditions: Works inside or outside. Is subject to intermittent exposure to heat, cold, excessive noise, rain, and wind; falls from ladders, steps, and slippery decks in foul weather. Is exposed to eye hazards while engaged in chipping paint. Is subject to some danger of drowning in case of accident. Subject to cuts from hand or powered tools and danger from flying splinters and chips. Subject to dust, grease, and soiling of clothing and skin surfaces. Due to the age of the vessel, the nature of some work activities require the use of protective clothing and equipment (e.g. rubber boots, coveralls, goggles, aprons, gloves, respirator, etc.) as situations warrant. The use of respirator (e.g. full face, half-face canister, N95) is required while performing some work activities to minimize the risk of exposure to chemical fumes, dust, lead paint, and/or asbestos.
Assumes responsibility for the operation and efficiency of the dredge's electrical systems and components.
Follows the plans and instructions laid out by the First Assistant Engineer or in his absence the Chief Engineer or Senior Engineer on board and is responsible for coping with unanticipated or emergency situations on their own
Makes scheduled and special operational checks of equipment. Observes gauges, listens, notes unusual conditions (heating, oil or grease loss, loose fittings, broken or inoperative units, etc.) and makes repairs or adjustments as required
Makes periodic or special preventative maintenance checks of units. Tests, dismantles, observes, replaces scheduled or work elements, lubricates, packs, repairs, etc., as indicated
Installs replacement or new equipment (floodlights, signals, fixtures, etc.) Repairs or participates in the repair of any electrical unit on board (motors, pumps, generators, control panels, special equipment, etc.)
Itemizes materials and parts used. Orders items that are readily available in quantities relevant to expectation of consumption. Maintains labeling and organization of spare parts storerooms and their contents. Changes instrument charts.